9
STEP 4:
Plastic Parts
1. Remove the Button Head Socket Screws holding the clamps of the left Release Lever (
40
) by using
the Allen Wrench (
115
). Install the Release Lever (
40
) onto the Handle Bar Seat (
6
) just behind the
Hand pulse sensors on the left side (when facing the front of the bike). Install it at an angle that allows
easy access for use, then reinsert and tighten the socket screws removed earlier. Don’t over tighten
these screws.
2. Secure the Steel Cable (
59
) to the Seat Handle Bar (
6
) with the Velcro Tape. Wrap the tape around
the handlebars in places that will be under the beverage holders so they are out of sight.
3. Attach the Pedals (L, R)(
116
,
117
) to the Crank Arms (
51L
,
51R
).Tighten with the Wrench (
132
).
Remember that the left pedal has a reverse thread and will be threaded onto the Crank arm in a
counterclockwise motion. There is an “L” stamped in the end of the threaded post of the left pedal and
an “R” in the right. Make sure to tighten the pedals as firmly as you can. It may be necessary to
re-tighten the pedals if you feel a thumping while pedaling the bike. A thumping or clicking noise is
usually caused by loose pedals.
4. Attach the Drink Bottle Holders (
L39
&
R38
) to the sides of the Seat Handle Bar (
6
) with four Sheet
Metal Screws (
105
).Tighten with the Phillips Head Screw Driver (
114
).
HARDWARE
#105.
4 x 16mm
Sheet Metal Screw
(4 pcs)
Содержание 161168325
Страница 22: ...22 Exploded View Diagram ...
