43
notice that the deck is dry. It is recommended that you reach between the belt and deck to verify there is lubrication present,
every other month. If you check and there isn’t any lubrication present, follow the procedure below even though the “Lube”
indicator isn’t lit on the console. Otherwise, lubricate when the console’s lubrication reminder lights after 90 hours of use. Use
the following procedure to apply the silicone lubricant:
1. Turn the power switch off and unplug the power cord from the wall outlet
2. Measure 18” from the edge of the motor cover; kneel down and reach under the belt approximately 4- 6” from one edge.
Squirt a line of lubricant about 1/8” wide x 15” long in an “S” pattern perpendicular to the motor cover.
3. Repeat the process on the opposite side.
4.
Plug the electrical cord back into the outlet and turn the power switch on.
5. Walk on the belt at a moderate speed for five minutes to evenly distribute the silicone lube.
6.
Note: If the “Lube” message appears on the console, perform the following procedure to reset the message:
7. To enter the Engineering Mode Menu press and hold down the Start, Stop and Enter
8.
keys, then at the same time insert the safety key. Keep holding the keys down until the Message Center displays Engineering
Mode Menu. Press the Enter button to access
9.
Press the Speed + button (or Speed – button to go backwards) until “Functions” appears; press Enter
10.
Press the Speed + button until “Maintenance”; press Enter, then the message center shows “LUBE MESSAGE RESET”, press
Enter.
11.
Press Stop to exit Engineering mode and resume use of your treadmill
Calibration Procedure
1.
Remove the safety key
2. Press and hold down the Start and Fast + buttons and replace the safety key. Continue to hold the Start and Fast key until
the window displays “Factory settings”, then press the Enter key.
3.
You will now be able to set the display to show Metric or English settings (Miles vs. Kilometers). To do this, press the up
or down key to show which you want, then press Enter. (The maximum speed is displayed in the speed window, and the
maximum elevation is displayed in the incline window.)
4.
Grade return – On (This allows the incline to return to zero when Stop is pressed.)
5. Press Start to begin calibration. The process is automatic; the speed will start up without warning, so do not stand on the belt.
