Spinnit FMMH 3.1, Руководство пользователя

Страница: 7 / 24

3 - Setting Up Your Machine
3.3 - Uncrating and Removing From the Pallet
Page 06
Remove the wooden framing around the outside box.
Remove the box up and over the machine.
Remove the four (4) 5/16” bolts which are securing the machine to
the pallet: access through the rear of the machine using a 5/16”
wrench (not provided) as shown in diagram 3-10. Discard the four
(4) 5/16” bolts.
Remove the FMMH-3.1 from the pallet carefully “stepping” it off
the edge. DO NOT drop the machine. DO NOT lift by the table.
Two people may be needed to remove the machine from the pal-
let safely.
3.3.1
3.3.2
3.3.3
3.3.4
3.4 - Leveling The Machine
Set the machine down in its desired location and determine if the
machine is level, making sure that it does NOT rock in any direc-
tion. If it does, determine which Leveling Feet need to be adjusted
and whether they need to be adjusted up or down.
If adjustment is needed, start by loosening the four (4) nuts which
are accessed through the rear of the machine.
Next adjust the four (4) Leveling Feet by screwing them clockwise
to raise them or counter-clockwise to lower. After each adjust-
ment set the machine down completely to verify that the machine
no longer rocks. Continue adjustment as needed until the ma-
chine sits securely in place. Tighten the four (4) nuts down to
secure the position of the Leveling Feet.
3.4.1
3.4.2
3.4.3
Diagram 3-10
Diagram 3-20
Leveling Feet
Base of the Machine
Nut
Wooden Pallet
5/16” Bolts 5/16” Bolts