Spinnit FMMH 3.1, Руководство пользователя

Страница: 13 / 24

4 - Operation
4.6 - Drilling Procedures
Page 12
4.6.1
4.6.2
4.6.3
4.6.4
4.6.5
4.7 - Tips on Drilling
4.7.1
4.7.2
4.7.3
4.7.4
Use a sharp drill bit at all times... Using the MS-1 drill bit sharpener, sharpen your drill bits regularly. Apply light pres-
sure when sharpening. Too much pressure may cause flaring of the tip. (Once a drill bit has a flared tip, it becomes
defective.)
Sharpening Stone... Use to debur the outside cutting edge of the drill bits for better performance.
Lubricate drill bits occasionally... Use Drill-Ease or Spin-Eze. While the drill is running, simply touch the Drill-Ease
stick to the drill bit or brush on the Spin-Eze. Drill through scrap to remove any excess. This will allow for a smoother
cut.
Drill Strips...When drilling, a drill bit must stop slightly above the drill strip. Replace worn out drill strips regularly to
ensure proper drilling.
After all your adjustments are made as desired, position the Table
in its primary position. Set the product to be drilled on the table
and make sure it is secure using the Paper Side Stops. To drill,
step down on the Foot Pedal and hold, raising the Table up to
meet the drill bits. Make sure the Table rises fully allowing the drill
bits to drill through the product. When the drill bits have penetrat-
ed through the entire stack of product, release the Foot Pedal,
which alows the table to return to its lowered position.
It is important you do not drill too slow or too fast. If you drill too
slow you can burn the paper leaving undesired marks. If you
drill too fast, the drill bits will act more like a punch and they will
break.
If your Table rises too slow: increase the speed of your Table
rise by turning the Table Adjustment Knob, located just under the
Table on the front of the machine, counterclockwise.
If your Table rises too fast: decrease the speed of your Table rise
by turning the Table Adjustment Knob clockwise.
Different product requires different speeds. It is always recom-
mended to drill through a test stack of the product until the opera-
tor is confident of the required speed.
Diagram 4-100
Product
Paper Side Stop
Table Adjustment
Knob
Foot Pedal