Sperry Marine NAVIKNOT 600 SD, Руководство по эксплуатации, установке и обслуживанию

Страница: 8 / 256

056353/J NAVIKNOT 600 SD
viii
General Safety Information for the Operator
WARNING
Risk of misusage
Before using the NAVIKNOT 600 SD, operators must be appropriately
trained and familiar with all operating procedures and safety instruc-
tions contained in this manual. The manual is to be completely read
before the first usage of the NAVIKNOT 600 SD system.
Keep all system manuals in a well-known, readily available location.
WARNING
Risk of misusage
The NAVIKNOT 600 SD is type approved as a speed and distance meas-
uring equipment only.
While the satellite PCB contained in the NAVIKNOT 600 SD electronics
unit produces position, heading and rate of turn data, these data are to
be regarded internal and may not be used for navigation purposes. The
data outputs on the satellite PCB may not be connected to external
equipment.
Under no circumstances may the NAVIKNOT 600 SD be used as a substi-
tute for mandatory equipment such as compasses or position receivers.
CAUTION
Invalid speed and distance information in „MAN“ mode of operation
In case of failure of the Doppler transducer, the NAVIKNOT 600 SD does
not provide valid speed and distance information and the system needs
to become operated in the alternative “MAN” mode of operation.
The function of the „MAN“ mode is to maintain normal operation of con-
nected speed receivers, such as gyrocompasses, RADAR, ARPA etc., by
transmitting valid output signals and data to the receiving equipment
connected.
Operating the NAVIKNOT 600 SD in the “MAN” mode may severely
affect the proper function of all equipment which depend on accurate
speed and/or distance data.
Always make sure that ship’s crew is aware of the fact that speed and dis-
tance information from the log are not valid, when operating the
NAVIKNOT 600 SD in the “MAN” mode.
CAUTION
Risk of damage through unauthorized service.
The NAVIKNOT electronics unit and CDU unit are generally not field-ser-
viceable on the component level. Defective units must be returned to
Sperry Marine for exchange.
Any service work on the electronics unit or CDU is to be carried out by
authorized service personnel only.
CAUTION
Risk of Damage
The CDU front plate is made of clear polycarbonate.
Do not clean the front plate with organic solvents, acetone or any other
substance which could damage or discolor plastic.
Use only water and soap or a mild detergent to clean the front plate.
Note The information and menu descriptions in this Operation, Installation
and Service Manual are applicable from software versions:
NAVIKNOT EU, Rev. D, 3.000
NAVIKNOT CDU, Rev. K, 2.000
Preamplifier D, IC-Flash Rev. F (V1.108); FPGA Rev. D (V1.112).