© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
5
802758
Step 4: Connect Drain Hose to Drain
Receptacle
Remove the drain hose from its shipping position on
the rear of the washer by unhooking the hose from the
retainer clamp and by removing the shipping tape.
Install the drain hose into the drain receptacle
(standpipe, wall or laundry tub) following the
instructions below.
IMPORTANT: Drain receptacle must be capable of
handling a minimum of 1-1/4 inch (3.2 cm) outside
diameter drain hose.
Standpipe Installation:
Place the drain hose into the standpipe.
Remove the beaded strap from accessories bag and
place around standpipe and drain hose and tighten
strap to hold hose to standpipe. Refer to
Figure 6
. This
will prevent the drain hose from dislodging from drain
receptacle during use.
Wall Installation:
For installations of this type, the drain hose MUST be
secured to one of the fill hoses using the beaded strap
from accessories bag. Refer to
Figure 7
.
NOTE: End of drain hose must not be below 24 in.
(61 cm).
FLW1990N
1
Water Faucets
2
Cold Water Connection
3
Hot Water Connection
4
Fill Hoses
Figure 5
Drain Flow Rate
Drain Height
Flow Rate
gallons per minute
(liters per minute)
3 ft. (0.9 m)
8.19 (31)
5 ft. (1.5 m)
7.27 (27.5)
6 ft. (1.8 m)
6.31 (23.9)
7 ft. (2.1 m)
4.89 (18.5)
8 ft. (2.4 m)
2.79 (10.6)
FLW1990N
1
2
3
4
FLW1992N
1
24 in. to 36 in. (91.44 cm recommended
height)
2
Standpipe - 2 in. (5.08 cm) or 1-1/2 in. (4 cm)
3
Beaded Strap
Figure 6
H023I
1
Drain Hose
2
Beaded Strap (tape if necessary)
3
Fill Hoses
Figure 7
FLW1992N
1
2
3
3
1
2
Содержание 802758R4
Страница 9: ......
