© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
3
802758
Installation
Step 1: Position Washer Near Installation
Area
Move washer as close to the desired area of
installation as possible.
NOTE: For best performance and to minimize
vibration or movement, install washer on a solid,
sturdy and level floor. Some floors may need to be
reinforced, especially on a second floor or over a
basement. Do not install the washer on carpeting,
soft tile, a platform or other weakly supported
structures.
Step 2: Position and Level the Washer
Position washer so it has sufficient clearance for
installation and servicing.
NOTE: Use of the dispenser drawer or washer door
as a handle in the transportation of the washer may
cause damage to the dispenser or door.
Place washer in position on a solid, sturdy and level
floor. Installing the washer on any type of carpeting,
soft tile, a platform or other weakly supported
structures is not recommended.
For easier access to leveling legs, prop up washer with
a wooden block. Refer to
Figure 3
.
Place a level on the cabinet top and check if the
washer is level from side to side and front to back.
NOTE: Level must rest on raised portion of top
panel. Refer to
Figure 3
.
If washer is not level, tilt washer to access the front
and rear leveling legs. Loosen the locknuts and adjust
legs by screwing into or out of washer base.
Make sure that the washer does not rock. When
washer is level and does not rock, tighten locknuts
securely against bottom of washer base. If these
locknuts are not tight, washer will move out of
position during operation.
Do not slide washer across floor once the leveling legs
have been extended. Legs and base could become
damaged.
Place rubber feet (supplied in accessories bag) on all
four leveling legs. Refer to
Figure 3
.
Verify that washer does not rock.
Step 3: Connect Fill Hoses
FLW2291N
1
Level
2
Wood Block
3
Rubber Foot
4
Leveling Leg
5
Locknut
6
Washer Base
Figure 3
Mixing Valve Flow Rates
Pressure
(psi)
HOT
gallons per minute
(liters per minute)
COLD
gallons per minute
(liters per minute)
20
1.6 (6)
2.5 (9.4)
40
2.2 (8.2)
3.4 (13)
60
2.6 (9.9)
3.8 (14.5)
100
2.5 (9.6)
4.2 (15.9)
120
2.6 (9.8)
4.2 (15.9)
FLW229
1
5
3
4
6
2
Under certain conditions, hydrogen gas
may be produced in a hot water system
that has not been used for two weeks or
more. HYDROGEN GAS IS EXPLOSIVE. If
the hot water system has not been used
for such a period and before using the
washer, turn on all hot water faucets and
let the water flow from each for several
minutes. This will release any
accumulated hydrogen gas. The gas is
flammable. Do not smoke or use an open
flame during this time.
W029
WARNING
Содержание 802758R4
Страница 9: ......