ASSEMBLY
NOTE: This product was partially assembled at the factory.
Step 1:
Remove the partially assembled unit from the shipping crate. It may be necessary to break down the crate for
easier removal. A forklift or additional help is recommended to safely remove the product from the crate.
Remove the left shroud (4) and the right shroud (5) by loosening the 1/4” x 3/4” bolts (1), the 1/4” lock
washers (2) and the 1/4” flat washers (3) as shown in the drawing below.
Partially assembled unit from crate
ITEM NO.
DESCRIPTION
QTY.
1
1/4” x 3/4” Bolt
9
2
1/4” Lock Washer
9
3
1/4” Flat Washer
9
4
Left Shroud
1
5
Right Shroud
1
For easier assembly place the rear end of the unit on blocks or something similar to keep it stable and level.
Once the tongue assembly, axle assembly and wheels are attached the, block can be removed.
Set the two shroud pieces and the hardware aside for the moment.They will be installed in a later step.
Page 7
NOTE:
There is another method of assembly if the beam assembly is too heavy to move around. Both flywheels
can be removed and put aside until later in the assembly process. The flywheels are held on a by a bolt on the
end of the gear. The flywheel with the grooves has a
left hand thread
and the other has a standard bolt that is
used as a set screw. Be extremely careful when removing flywheels.They are very
HEAVY.
Reattach the flywheels
after step 4 once the tongue and wheels are attached.
4
5
Flywheel with
grooves
