OPERATION
STEP 1:
Set up the log splitter in a clear, level area and block the wheels. Disconnect the log splitter if it is attached to a
towing vehicle.
STEP 2
: Start the engine after making sure that it has an adequate oil and fuel supply. The throttle should be set at the
maximum speed to develop the required power. Refer to Kohler engine manual for more detail.
STEP 3:
Place a log on the beam cradle against the wedge.
STEP 4:
With the engine running, push in the green safety button on the side of the shroud and push down on the
control handle. Remove the split log and split the pieces in half if desired. The log splitter will not operate unless
both hands are used to activate the ram.
STEP 5:
Repeat steps 3 and 4 to continue with the next
log.
Page 13
NOTE
: Make sure that the engine has oil and gas before starting. See your Kohler engine manual for recommendations
on oil, starting and maintenance.
STARTING INSTRUCTIONS (Kohler SH265))
1) Move the fuel lever to the “ON” position.
2) For a cold engine put the throttle control midway between “SLOW” and ‘FAST.”Place the choke control into the “ON”
position.
3) For retractable start engine turn engine ON/OFF switch to “ON.” Slowly pull the starter handle to just past compression.
STOP! Return starter handle. Pull firmly with a smooth steady motion until it starts.
4) Gradually return the choke control to the “OFF” position after the engine starts and warms up.
5) For a warm engine put the throttle control between “SLOW” and “FAST.” A warm engine usually does not require the
choke on.
STOPPING THE ENGINE
1) If possible, remove the load.
2) Move the throttle control to the “SLOW” or “LOW” idle position.
3) Turn key switch or on/off switch to “OFF.” Move throttle to “STOP” position if equipped.
4) Close the fuel shut-off valve.
ENGINE OIL RECOMMENDATIONS (Kohler SH265)
For temperatures above 32 degrees F use an 10W-30 oil. Using mutigrade oil may increase oil consumption. Using SAE
30W oil below 40 degrees F will resuilt in hard starting and possible engine bore damage.For temperatures below 32
degrees F use an SAE 5W-20 or SAE 5W-30 oil. Oil capacity is about 0.63 qt. ( 0.60 L)
