Spectrum RAC2V1A, Руководство пользователя

Страница: 22 / 93

Advanced Configuration Options
RAC2V1A Router User Guide 22
3. Click Client List in the side menu to display the Client List screen.
4. Click Add to add a reserved IP client. Select an existing DHCP client
and then click Delete to delete the reserved IP for the client. Click
Refresh to update the Attached Client List.
Selecting the NAT Mode
NAT (Network Address Translation) allows the router to manipulate IP
addresses so that just one single IP address can represent an entire
group of computers on the network and let them all communicate with
the Internet. This conserves IP addresses and is necessary in IPv4 since
there are a limited number of available IP addresses for use. (This
limitation does not affect the IPv6 address space.)
Perform the following steps to select the NAT Mode.
1. Access and sign in to the configuration interface.
2. Click the LAN Setup tab.
3. Click LAN Settings (IPv4) in the side menu to display the LAN
Settings screen.
4. Select the NAT Mode from the NAT Mode field drop-down list. The
optional modes are:
o
Bridged: Data will pass through the router directly without any
routing and without NAT.
o
RoutedWithNAT: Data will be routed by the device and all the
outgoing packets will be NATed.
o
RoutedWithoutNAT: Data will be routed by the device but all the
outgoing packets will not be NATed.
5. Click Apply at the bottom of the screen.
Note: A dialog box prompts you to restart the router. Click OK to
restart.
Setting the Wireless Mode
You can set the wireless mode to optimize performance based on the
type of network adapters being used by the client devices (for example,
820.11g, 802.11n or 802.11ac). Select the proper mode to support all of
the wireless devices that will connect to the router.
Perform the following steps to set the wireless mode.
1. Access and sign in to the configuration interface.
2. Click the Wireless tab.