6
STEP
4
Install Water Storage Tank
T
The Tank Ball Valve fitting on the Water Storage Tank may need to be tightened 3-4 turns to get a good seal.
Do not over tighten.
TO INSTALL WATER STORAGE TANK:
1
Apply 2-3 wraps of Plumber’s Tape
H
to the threads on the nipple at the top of the Water Storage Tank
E
2
Locate the Tank Connector
D
. Hand tighten onto the Water Storage Tank
E
nipple 3-4 turns, being careful not to
cross thread or over tighten.
3
Do not connect the tube at this time. This will occur later in the assembly.
4
Place the Water Storage Tank
E
next to the Reverse Osmosis Filter System Assembly. The Water Storage Tank
E
can
be placed upright or on its side. Use provided mount stand.
STEP
5
Install RO Tap
SELECT LOCATION OF REVERSE OSMOSIS TAP MOUNTING HOLE
You will need to select the location of the Reverse Osmosis Tap
P
. You have three options to choose from:
Use an existing sink top hole. This may be blank. This is for the spray hose or soap dispenser
(Must be between 1-3/8” and 1-5/8” in diameter)
Drill a new hole in the sink
Drill a new hole in the countertop next to the sink
1
Determine where you are going to install your RO Tap Body
P
.
2
Check to ensure the RO Tap Body
P
will mount flat against the mounting surface.
3
Visually review the routing of the tubes from the RO System Head
A
to the RO Tap Body
P
. Check to ensure there is
adequate tube routing space between the RO Tap Body
P
and RO System Head
A
.
4
If drilling is needed, drill a 1-3/8" diameter hole in the mounting surface.
IMPORTANT: Drilling of surfaces made of stone or solid surface materials such as granite, marble, or other plastic resin
or sinks made of porcelain and stainless steel may cause permanent, irreparable damage to the sink or countertop surface.
4
E
D