Left slotted
uprights
Right slotted
uprights
Front bar Assembly
Rear bar Assembly
0191559R1 Page 3 of 9
Assemble bar supports
1. The bars should be assembled with the tabs facing away from
each other as shown in
Figure 1
.
2. Loosen the (2) wingnuts slightly.
3. Repeat for the 2nd set of bars.
1
X 2
Bar support B-side
(with slots)
Bar support
(with threaded weld studs)
8-32 Wing nut
(2 per assembly)
Tab
Tab
Figure 1
1. Determine the approximate location (height) you would like the
module to be mounted. The rear bar is (1) slot higher than the front.
2. Insert one tab into a slot in the left slotted upright.
Figure 2
.
3. Insert the opposite tab into the corresponding right slotted upright
and fully extend the bar assembly into place.
4. Lock the extended position of the bars by securely tightening the (2)
wingnuts. Be sure both wingnuts are tight.
5. Repeat for the 2nd set of bars.
Note: When determining the location of the module, be sure the
module will clear any obstructions that may be inside the cabinet
and enough clearance (height) is provided for all module devices.
Figure 2
Install bars into cart
2
