0191559R1 Page 5 of 9
Figure 5.1
Dividers
5
X 10
2. Place dividers into universal tray slots where needed.
Figure 5.2,
Figure 5.2
Figure 5.4
Bar assembly
Divider
Figure 5.5
5. Route each charge cord through a tray hole and around the divider.
Secure cord to divider using the slot.
Figure 5.5
.
4. To lock each divider into place, bend both tabs 90-degrees.
Figure 5.4
.
1. Pull dividers off bar assembly.
Figure 5.1.
Figure 5.3
3. See p.6 for spacing / location suggestions.
Figure 5.3
.
Charge cord
Note: Dividers are designed for semi-permanent installation
and use on the universal tray. Dividers can be repositioned
by straightening the tabs, but excessive bending / re-bending
cycles can cause the tabs to break.
Divider
Robot
