TECHNICAL GUIDE ADDENDUM
TOUGH GUN™ ThruArm™ G2 Series
TOUGH GUN I.C.E.™ Neck Installation
for Motoman® Robots
TOUGH GUN I.C.E. INSTALLATION
NOTE:
Tregaskiss LSR Unicable not available for TOUGH GUN I.C.E Gun assemblies. Motoman OEM unicables
MUST be used for TOUGH GUN I.C.E. installations.
Pull the red and blue water lines through the Flange-Cable Connector and Cover Mounting Ring as
shown.
INSTALLING NECK / NECK REPLACEMENT
IMPORTANT!
Remove consumables (i.e. retaining head, nozzle and contact tip) before installing neck. Failure
to do so with result in improper installation.
Twist the hand nut clockwise to UNLOCK.
IMPORTANT
: To prevent damage to the neck, ensure that the
hand nut is always in the UNLOCK position when inserting a neck.
Insert the neck into the connector housing.
IMPORTANT
: The neck is fully inserted only when the neck
bottoms out and the insertion depth guide (INSERT TO HERE) on the neck meets up with the connector
housing.
Release the hand nut allowing it to return to the LOCKED position.
IMPORTANT
: Do not release the hand nut
unless the neck has been fully inserted or damage to the neck may result.
MOTOMAN OEM CABLE
COVER MOUNTING RING
TOUGH GUN I.C.E. WATER LINES
FLANGE-CABLE CONNECTOR
RED
BLUE
