0190035R1 Page 6 of 8
Figure 4A
Figure 4C
Figure 4B
Table operation
To adjust the worksurface height, press and hold the adjustment buttons
on one leg and raise or lower the worksurface and upper leg assembly
(slightly twisting then sliding the leg after the button has been pressed will
help keep it retracted until its aligned with the new hole.)
Figure 4A
. Align
the buttons with the adjustment holes to lock the leg into the new position.
Repeat this procedure on the other leg while making sure to use the same
hole position on both legs.
To flip-up the worksurface, pull the release lever and lift up the edge of
the worksurface until it locks into a vertical position.
Figure 4B
. To lower,
pull the release lever while lowering the worksurface-be sure it locks into
place. Multiple tables can be “nested” together next to a wall to save
space.
Figure 4C
.
Adjustment button on
each leg provides 9” of
total height adjustment
in 1” increments
Accessories
Release Lever
Leg Channel - 37318
• Provides ability to route wires and cables from the floor to the
worksurface (Use with Cove or other power modules-not included)
• High-impact polystyrene
• Color-black or silver
• Installs with double-sided tape
• Internal size (nominal):
1.75”W [4.44 cm] .5”D [1.27 cm] x 15”H [30.5 cm]
• Shipping weight (nominal): 1 lb [.454 kg]
Silver
Black
2” Dia
15”
