0190035R1 Page 3 of 8
Wire management installation - Optional
1. Align the cord tray with the table mounting holes and attach with (4)
1/4-20 x 5/8” PHM screws.
Figure 3A
.
2. If you have a “Chalk white dry erase” worksurface, remove the
protective film.
3. Determine which leg the channel will be attached (left or right). The leg should
be free of dirt, dust, grease and moisture to maximize tape adhesion.
4. Place the leg channel along the inside of one of the legs using the
adjustments holes as guides.
Figure 3B.
The channel can be
attached next to the buttons, but the buttons need to operate freely.
Do not install over the buttons or adjustment holes.
5. Remove the two tape backers and apply pressure to the channel
along the entire length to secure.
6. To install a Cove module, route power cord through cutout, then set
module into place and secure with thumbscrews.
Figure 3C
.
Adjustment
button
Leg
Figure 3A
Figure 3B
2-sided tape
2-sided tape
Adjustment
button
Le
g
C
h
an
ne
l
(1) 0130711
Leg Channel
(1) 0130366
Optional Cord Tray
37318
(sold separately)
(4) 0101382
#14 x 7/8” PHSM
screw
(4) 1/4-20 x 5/8”
PHMS
Leg channel
(sold separately)
User-side
Optional Cord Tray
(1) 026057
#10 x 3/4” PHSM
screw
(1) 051070
Cord Clip
Note: Wire management accessories may or may not be included.
