Cord management options
Cords and wiring can be channeled cleanly throughout the unit using
grommet holes and openings in the bottom of the technology compartment.
The 3.5” grommet inside the legs
can be used to route power / data
cords up from the floor.
The openings near the eLift legs
can be used to route power /
data cords up from the floor.
eLift legs
Figure 7C
Figure 8
Side panel stop adjustment
If necessary, the offset panel stops can be adjusted to slightly shift
the closed position of the panels and lock rods.
1. Loosen the JC bolt slightly with a 4mm hex wrench.
Figure 8
.
2. Rotate the stop until the panel is positioned correctly. Be sure
the lock rods engage easily.
3. Re-tighten the JC bolt securely.
4mm hex
wrench
Tools
Required
0115700R2 Page 8 of 17
Set-and-go legs
Fixed legs
3.5” grommet
Figure 7B
Figure 7A
