0115700R2 Page 7 of 17
6. Install side worksurfaces
1. Set the 2 side worksurfaces onto the table and align the mounting holes.
Figure 6A
.
2. Attach each side worksurface to the table with (4) 1/4-20 x 2-3/4” PHM screws. Do not tighten completely.
3. At each unit-to-unit bracket connection, line up the seams and edges of the previously installed end
worksurfaces with the side worksurfaces. This may take 2 people.
4. Attach a unit-to-unit bracket at each worksurface seam with (4) 1/4-20 x 5/8” PHM screws.
Figure 6B.
When everything is aligned and without gaps, tighten the unit-to-unit brackets securely.
5. Install a 1/4-20 x 5/8” PHM screw through the remaining hole in each cantilever worksurface bracket and
into the side worksurface.
6. Tighten
all
screws securely.
7. The center console panel can now be installed. See instructions included with the panel.
5. Attach support plates to side worksurfaces
1. Place the side worksurfaces laminate-side down
onto a non-abrasive surface.
Figure 5
.
2. Attach a support plate to each worksurface with (2)
1/4-20 x 5/8” PHM screws and tighten securely.
Figure 5
side worksurface
support plate
1/4-20 x 5/8” PHMS
(2 required)
Figure 6A
side worksurface
1/4-20 x 2-3/4” PHMS
(4 required per side worksurface)
side worksurface
end worksurface
(optional)
end worksurface
(optional)
1/4-20 x 2-3/4”
PHMS
dual unit-to-
unit bracket
Figure 6B
Phillips
screwdriver
Tools Required
Cordless drill
with long magnetic
Phillips driver
or
(best)
Phillips
screwdriver
Tools Required
Cordless drill
with long magnetic
Phillips driver
or
(best)
