Installing the Detector
34
SharpEye™
Single IR Flame Detector User Guide
3.1.5
Aiming the Detector
•
The detector should be aimed toward the center of the detection zone and
have a completely unobstructed view of the protected area.
•
Whenever possible, the detector face should be tilted down at a 45º angle to
maximize coverage and prevent accumulation of dust and dirt.
•
Do not start an installation unless all conceivable considerations regarding
detection location have been taken into account.
Installation should comply with
NFPA 72E or any other local and
international regulations and standards
, as applicable to flame detectors and
installation of Ex approved products.
3.2
Unpacking the Product
Upon receipt of your detector, verify that you have received the following
contents:
•
Delivery form
•
Flame detector
•
Plastic weather cover
•
User manual
•
Quality document
•
Tool keys (per shipment)
Check and record the following:
•
Verify the appropriate Purchase Order.
•
Record the Part Number (P/N) and Serial Number of the detectors, and the
installation date in an appropriate logbook.
•
Verify that all components required for the detector installation are readily
available before beginning the installation. If the installation is not completed
in a single session, secure and seal the detectors and conduits/cable entries.
3.2.1
Checking the Product Type
Check that your product has the configuration/options that you ordered. Check
the detailed part number on the label and compare this information with the
descriptions contained in
on page 16.
3.3
Required Tools
The detector can be installed using general-purpose common tools and
equipment. Table 12 lists the specific tools required to install the detector.
