Spectrex SafEye Xenon 700S, Руководство пользователя

Страница: 56 / 80

Alignment of Unit
56 SafEye
TM
Xenon 700S Gas Detector User Guide
Notes:
 To ensure proper alignment according to factory calibration, prior to
telescope installation, verify that the telescope and its sight mounting
are free of dirt.
 To ensure optimal alignment, do not attempt to change factory
calibration of the telescope or its mounting.

To align the unit (see Figure 10):
1
Ensure that the detector and the flash source are installed
properly. Installation instructions are described in Installation
Instructions, page 43.
2
Install the telescope assembly (Item 12) on the telescope site
mounting of the source according to the drawing. Fasten the
telescope with fastening screws (Item 13).
3
Crude alignment:
 Use ¼” Allen screw driver for all alignment screws.
 Loosen screws 5 and 6.
 Approximately aim the source horizontally toward the detector.
 Tighten screw 6.
 Loosen screws 3 and 4.
 Approximately aim the source vertically toward the detector.
 Tighten screw 3.
4
Repeat step
‎
3 for the detector towards the source.
5
Fine Alignment:
 Aim the source to the detector within horizontal axis using
screw 7. Aim the telescope cross toward the front level of the
telescope site or the detector.
6
Tighten screw 5.
7
Aim within the vertical axis using screw 8.
8
Tighten screw 4.
9
Make sure the telescope cross is pointing to the center of the
detector and source window.
10
Repeat step
‎
5 for the detector alignment.