SpectraPure
®
SpectraPure
®
Inc.
480.894.5437 Call us toll-free 1.800.685.2783
2167 East Fifth St, Tempe, Arizona 85281
11
Drain Saddle Mounting Locations
Figure 8: Drain Saddle Assembly Sequence
DRAIN SADDLE INSTALLATION
1. Refer to Figure 7 and determine the location for the drain saddle assembly and drain hole. It must be located above
the “P” trap (“U” shaped bend in drain pipe) on the sink side of the drain pipe.
2. Place the half of the drain saddle with threaded nipple at a predetermined location. Slide a pencil through the
plastic nipple and make a mark on the drain pipe.
3. Use a small punch and indent a start position to prevent the drill bit from wandering.
4. Drill a 3/8" hole in the drain pipe through the mark
on one side only,
do not drill through both sides of the drain
pipe. Clean any loose shavings from around the hole.
5. Refer to Figure 8 showing the drain saddle assembly sequence. Press nuts in back half of drain saddle assembly.
6. Align the front half of the drain saddle by inserting a pencil through the plastic nipple and the newly drilled hole in
the drain pipe.
7. Install the back half of the drain saddle and clamp assembly to drain pipe by screwing in the mounting bolts until
snug.
