2.6
2.6
2.6
2.6
2.6
MANU
MANU
MANU
MANU
MANUAL SET PROCEDURE
AL SET PROCEDURE
AL SET PROCEDURE
AL SET PROCEDURE
AL SET PROCEDURE
The TimeView 400 can be manually set for operation as
a stand-alone display clock. Time is entered using the
rear panel MODE and SET switches. The MODE switch
advances the clock through the setting process and the
SET switch selects the time variables. Depressing and
releasing the SET switch causes the clock to increment
through the time variables. Depressing and holding this
button causes the display to scroll through the time
variables. The setting process sets the hours and min-
utes. Seconds are reset to zero at the end of the setting
process.
TimeView 400 cannot be manually set when connected to
an RS-485 data bus. The presence of the RS-485 data
stream disables the MODE and SET switches.
2.6.1
2.6.1
2.6.1
2.6.1
2.6.1
Manual Set Procedure
Manual Set Procedure
Manual Set Procedure
Manual Set Procedure
Manual Set Procedure
To prepare the clock for Manual Set operation, place the
termination switch, Switch 10, in the ON position. Switch
7 may be placed in either the COMPUTER SET position ON,
or OFF for the NetClock SET mode. Apply power to the
clock. Observe that the hours, minutes, and seconds
digits light up sequentially.
2.6.1.1
2.6.1.1
2.6.1.1
2.6.1.1
2.6.1.1 Set Hours
Set Hours
Set Hours
Set Hours
Set Hours
Hours are entered in a 24-hour format, even if the 12-
hour display format is selected. For example, when
setting the TimeView 400 for 2:00 PM, enter 14 for the
hours value. To set hours, depress and release the MODE
switch. The hours digits blink and show the current hours
value. If the displayed value is appropriate, depress the
MODE switch to advance to the Set Minutes routine. To
change the hours value, depress and release or hold
down the SET
button to advance through the hours
variables. When the desired hour value is displayed,
release the SET button and depress the MODE button to
advance to the Set Minutes routine.
Page 2-18
