Spectra Vista Corporation SVC HR-1024i, Руководство пользователя

Страница: 102 / 118

SVC HR-1024i / HR-768i / HR-640i / HR-768si / HR-512i USER MANUAL REV 1.12
A P P E N D I C E S 9 7 9 7 9 7 9 7
PDA Power Up
If the PDA is turned off, or automatically powers down while the PDA application is in use, it may be
necessary to perform a Soft Reset on the PDA, followed by a restart the PDA application.
In general, after turning on the PDA and before beginning a series of new scans with the PDA application,
it is recommended that the operator always first perform a Soft Reset on the PDA.
PDA Charging
Even when not in use, the PDA should be periodically recharged every few weeks. This process allows the
PDA’s internal backup battery to maintain the PDA application installation and configuration.
Failure to maintain the charge on the PDA’s internal backup battery will cause the PDA application to be
lost. In this case the PDA application must be re-installed from the supplied CD.
PDA COM Ports And PDA Application Software
The PDA Application Software’s “Instrument->Connect” menu displays a list of COM ports that are
available to establish the connection to the instrument. A typical list, as displayed, is shown below:
The list of COM ports displayed in this dialog (COM1 and COM8 in the example above) may vary from
one PDA installation to another.
The COM ports shown in the dialog are read from the application’s INI initialization file at program
startup. See Appendix B – File Descriptions PDA Software COM Port Configuration File for the format
of this initialization file.
The COM1 port is typically fixed and corresponds to the 9-pin RS-232 connector found on the PDA.