Spectra Precision SP90m, Руководство пользователя

Страница: 85 / 164

73
When corrections are received and used, is displayed on
the General Status screen together with the age of corrections
(see
General Status on page 27 ).
To configure the receiver as a Dual RTK rover, use the Web
Server as follows:
• Go to
Receiver
>
Position
>
Rover Setup
.
• Set
Processing Mode
to
Dual RTK
.
• Specify how the corrections are being forwarded to the
receiver by setting
Input Mode
accordingly.
If you choose
Automatic
, the receiver will find by itself
which of its ports are used to acquire corrections.
If you choose
Manual
, you need to specify each of the two
ports. The “
RTK-1
” line will define the port routing the
corrections allowing the receiver to compute the position
of the primary antenna, whereas the “
RTK-2
” line will
define the port routing the corrections allowing the
receiver to compute the position of the secondary
antenna.
NOTE: The same set of corrections, hence the same port,
can be used for both antennas.
• Additionally, in the
Other Settings
section, you may change
the primary GNSS system used (
GPS
is the default
selection), limit the level of position accuracy to less than
what the receiver can actually achieve in this case.
Typically you will choose
RTK Position
to match to the
selected operating mode.
• Select the model of dynamics that suits the movement
pattern of your rover best.
• Click
Configure
.
• Set the device used by the receiver to acquire corrections:
– If corrections are received via radio, go to
Receiver
>
Radio
to enter all radio parameters. You may use the
internal radio or an external radio.
– If corrections are received over the Internet, go to
Receiver
>
Network
to set the device used (this may be
Ethernet, Modem or WiFi; more information about how
to set up theses devices can be found in the relevant
context-sensitive Help). Then go to
Receiver
>
I/Os
to
start data reception in NTRIP or Direct IP mode.