Spectra Precision SP90m, Руководство пользователя

Страница: 49 / 164

37
When you activate ATL recording, the screen looks like
this:
Then make a long press on Escape to return to the General
Status screen so you can freely use the other screens.
To stop ATL recording, go back to the ATL Recording
screen and press
OK
. Press
OK
again as a positive answer
to the message “
Stop ATL?
”. ATL recording stops right
away.
2.
Reset configuration?
: This screen allows you to reset the
receiver. You need to confirm this request before the reset
actually takes place.
During a reset, all parameters are reset to their defaults,
except for ephemeris, almanac, position and time data.
SBAS ephemeris data are however cleared. Then the
default_config.cmd file is run if present.
”
RESET IN PROGRESS
” is displayed throughout the
sequence (which may take a few minutes). At the end of
the sequence, hold the
Escape button depressed for a few
seconds to return to the General Status screen.
3.
Upgrade firmware?
: Allows you to upgrade the firmware of
your receiver.
When Spectra Precision releases a new firmware version,
copy the corresponding *.tar file to a USB key then
connect the key to the receiver via the USB connector on
the receiver front panel.
Once done and after selecting the
Upgrade firmware?
function, the screen will show the firmware version you
can now install. Press
OK if you agree and let the receiver
complete the installation. For more information on
firmware upgrades, see
page 45 or web page
Receiver
>
Configuration
>
Firmware Upgrade
in the Web Server.
4.
Execute script?
Allows you to have the receiver executing
all the proprietary commands listed in the *.cmd file
stored on the connected USB key.
5.
Startup Protection Active
: This screen is visible only if the
startup protection has been activated through the Web
Server. It is visible under the
Advanced Settings
screen but
will also pop up whenever you want to enter the edit mode
for any of the receiver parameters.