Engl
ish
11
Using SP60 for the First Time
WARNING
-
This receiver uses a rechargeable Lithium-ion
battery. To avoid personal injury or equipment damage, make
sure that you read and understand the safety information at
the front of this guide.
The battery is shipped partially charged. Depending on the
time elapsed since then, the remaining charge may be even
less. For this reason, you should first recharge the battery
completely before first use. (See warnings and safety
information at the front of this guide.)
Charging the
Battery
1. Set up the battery charger as follows:
– Connect the output cable (
[1]
) of the AC/DC power
block (
[2]
) to the battery charger input (
[3]
).
–
Choose the power cord (
[4]
) that is suitable for your
country.
–
Connect the end of the power cord to the AC/DC block
input (
[5]
), and the other to a power outlet (
[6]
). This
powers up the battery charger, causing the two LEDs
[8]
to turn solid red.
2. Insert the battery (
[7]
) into one of the two slots on the
battery charger (give the right orientation to the battery).
When the battery is detected, the corresponding red LED
(
[8]
) will go off and the nearby LED (
[9]
) will start blinking
green to indicate that the battery is being charged.
3. Charging the battery will take a few hours. When the
battery reaches full charge, the LED (
[9]
) will turn solid
green (see also printed instructions provided with the
charger).
4. Remove the battery from the charger when fully charged.
NOTE 1: The battery may be left on the charger for an
indefinite period of time without causing any damage to
the charger or the battery.
NOTE 2: If you also have a spare battery, the two batteries
can be inserted onto the charger. The batteries will be
charged one after the other.
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[9]
[8]
[8]
[9]
