Speco N64NR, Руководство пользователя, Страница: 19 / 114

EZ Setup & Main Interface
NVR User Manual
4 Add Camera . Add cameras via PoE first before adding any cameras from the LAN. Speco cameras added via the
PoE ports will automatically be added to the corresponding channel. To add cameras from the LAN, make sure all
cameras are set to DHCP. Click “Refresh” to refresh the list of online IP cameras which are in the same local network
with NVR and then click
to add the searched camera. Click “Add All” to add all the cameras in the list. Click to
delete the added camera. Click “Delete All” to delete all the added cameras.
Click to edit the searched IP camera as shown on the below left. Enter the new IP address, subnet mask, gateway,
username and the password of the camera. You can check “Sync to IPC” to modify the IP address of the IPC via
different network segments for being in the same network segment with the NVR. Click “OK” to save the settings.
Click to edit the added camera as shown on the above right. Enter the new camera name, IP address, port,
username and the password of the camera. You can click “Test” to test the effectiveness of the input information. Click
“OK” to save the settings. You can change the IP camera name only when the added camera is online. Click “Next” to
continue.
5 Disk Settings.
You can view the disk number, disk capacity of the NVR and serial number, R&W status of the
disk. Click “Formatting” to format the disk. Click “Next” to continue.
6
Record Settings
. Two record modes are available: auto and manual.
Auto
: Select one auto mode in the interface as shown below and then click “Next” button to save the settings. Click
“Advanced” to self-define record mode. See 7.1.1 Mode Configuration for details.
12