Speck Badu EcoMV, Инструкция по установке, эксплуатации и обслуживанию

Страница: 27 / 38

18
Part # M017898010000 August 31, 2012
ECOTECH EZ
®
Variable Speed Motor/Control
Unit must be in Stop mode to access programming. If RUN/STOP button is lit press RUN/STOP to turn off light and put
in Stop mode.
1. Press the right arrow and EXIT button at the same time
for 2 seconds (Note: the unit must not be running “STOP”
condition, before setting program).
2. Use the (left arrow) and (right arrow) to move through
the time and flow setting process. Use (up arrow) and
(down arrow) to increase or decrease Time and Flow.
% Flow Range: 30 – 100%
Time Range: 0-10 minutes
(Note: Set time to 0 to disable priming)
3. After you have set the desired Pump Priming program,
press ENTER to save. The example shown on the display
is for a 2 minute priming time/duration at 75% Flow.
4. If finished programming, push RUN/STOP button to run
program.
(Note: RUN/STOP button should be lit)
Programming for Pump Priming (change from default setting)