Speck pumpen IN-VB, Перевод оригинального руководства по эксплуатации, Страница: 84 / 100

Maintenance
34 EN 11|2018
Cartridge Seal
MIN + 1.5 mm
MIN
WG56.00.011-P
Fig. 19
8.6.6 Assemble mounting brackets – only for incomplete machines
 Observe figure 14.
1. Place the mounting brackets (89-11.03) in the drive lantern (161) from above.
2. Assemble both coupling halves (849) on the shaft (211). The mounting bracket (89-11.03) should lie
between the coupling halves (849).
3. Tighten the hexagon socket screws (914.1).
4. Assemble the coupling guard (681) on the drive shaft (161) using the hexagon socket screws
(914.2).
8.7 Screw tightening torque
 Observe the following torque values during assembly. See point 10.2 on page 44
Part no. Description Thread Starting torque [Nm]
800 Motor M6 10
M12 70
M16 70
903.1 Screwed plug R 3/8 15
903.2 Screwed plug R 1/4 until IN-VB 25: 15 Nm
from IN-VB 40: 10 Nm
914.1 Hexagon socket screw M6 St 16
M8 St/GG 30
M8 Al 22
M10 70
901.1 Hexagon socket screw M6 10
M8 10
M10 50
M12 70
M16 70
914.3 Hexagon socket screw M5 4
M6 10
M8 10
922 Nut M10 28
M12 50
920.1 Nut M8 12
M10 20
M12 25
M16 50