Spearhead Twiga 555, Руководство пользователя

Страница: 15 / 63

Spearhead TWIGA
14

A linkage isolation facility is necessary for all models. Set linkage lift rods to
an equal length.

All machines require a 12v fused supply. A 30 amp DIN connector is
provided, but if not, the lead should be taken directly to the vehicle battery.
Avoid cigarette lighter plugs as they are unsuitable. The supply cable has a
red wire for positive (+ve) and black wire for negative (-ve)

Spearhead particularly recommend “Category 2” three point linkage of ball
end type, we do not advise the use of claw type hitching. The quick release
latches should be checked, if worn or insecure they may cause accidental
damage or personal injury if the machine becomes detached.

The machine is sold to suit Cat. 2 linkage, some modification may be
necessary before mounting on Category 3 linkage.

Ensure tractor link arms can be isolated from accidental lifting.
Note
For machines fitted with an oil cooler it is important to connect a separate lead direct
from the battery to the oil cooler control box.
Lifting Points for use with pallet forks.
Attaching your machine to the tractor – Using Axle
mounting
Warning
It is most important the operator fully understands the procedure for
attaching/un-attaching the reach mower to/from the tractor. The
following text must be fully understood before attempting to attach the
machine. If there is any doubt please contact your supplying dealer or
Spearhead Service Department. Failure to follow the correct procedure
To attach/unattached the machine could result in personal injury or machine damage. Any
resulting damage to a machine is not covered by warranty.
Always be sure to select a level firm surface, such as concrete before attaching to the tractor.
When operating the tractor or machine’s controls do so only when seated in the tractor cab.
Do not allow anyone to stand on or amongst linkage for any reason.