8999071EN: v1.410/10/2019
21
Original instructions (ENGLISH)
Website: www.spearheadmachinery.com
8.2
Oil Level Control
Use always the same type of oil, SAE 90. For gearbox we need 1.2 l of oil. Use the hole on the top of gearbox
for filling in (Figure 32(1)). For pouring in use a funnel. Pour in the oil till the level of the control plug on the
gearbox). A plug for oil control is placed on the side of the gearbox (Figure 32(2)). For changing the oil use plug
under the fixing plate
– unscrew it (Figure 32 (3)).
Figure 32
8.3
Bolt Tightening
Figure 33
IMPORTANT:
On every eight hours check that all nuts are tighten enough.
IMPORTANT:
Never tighten the nuts on the connecting part (Figure 33 (1)) completely; the connecting parts
must remain movable. Proper tighten nuts are when tighten the nuts till the end and then loose them for ¼ of the
round.
IMPORTANT:
At greasing use the gloves. After greasing always wash your hands.
IMPORTANT:
Use type LIS 3 for greasing.
8.4
Greasing
The machine has the following greasing points:
Left and right bearing on the rotor shaft (Figure 40(1), Figure 41)
Left and right bearing on the rear roller (Figure 40 (2))
Pins of the arm (Figure 34, Figure 36)
Connection (Figure 35)
End parts of PTO shaft
Hydraulic cylinder (Figure 37)
Lifting system (Figure 38, Figure 39)
IMPORTANT:
Before any greasing operation read these instructions.
