20
AFTER SALES SUPPORT
0345 605 2070
OPERATE
When diameter of wood being cut is greater than the
bar length, make 2 cuts as shown.
Limbing
Bucking
Limbing a tree is the process of removing the
branches from a fallen tree. Do not remove supporting
limbs (A) until after the log is bucked (cut) Into lengths.
Branches under tension should be cut from the
bottom up to avoid binding the chain saw.
Warning: Never cut tree limbs while standing on tree
trunk.
Bucking is cutting a fallen log into lengths. Make sure
you have a good footing and stand up hill of the log
when cutting on sloping ground. If possible, the log
should be supported so that the end to be cut off is
not resting on the ground. If the log is supported at
both ends and you must cut in the middle, make a
downward cut halfway through the log and then make
the undercut. This will prevent the log from pinching
the bar and chain.
Be careful that the chain does not cut Into the ground
when bucking as this causes rapid dulling of the
chain. When bucking on a slope, always stand on the
uphill side.
> Log supported along entire length: Cut from top
(over buck), being careful to avoid cutting into the
ground
A
