Spatherm SEO L, Инструкция по установке и эксплуатации

Страница: 19 / 40

GB
GB
19
To activate the swivel function, you must first operate the stop on the rotary
base. This detent pin is located centrally in the lower storage area (Figs.
7b and 7c).
After pulling out the spring-actuated stop,
the top cube can be swivelled 30° in either
direction. After swivelling, lock the stove in
its final position by engaging the stop (Fig.
7d).
Fig. 7c
Fig. 7b
3
Fig. 7d
3.4 RATING PLATE
The rating plate is located on your warranty certificate and also on the
back of your stove. It contains technical data and notes. Never remove the
rating plate because it confirms that the appliance has been tested, and it
is also required for the acceptance procedure and annual inspections by the
chimney sweep.
4. COMBUSTION
4.1 INITIAL COMMISSIONING
The SEO S / SEO L stove must only be installed and set up by a special-
ised company. Initial commissioning must only be executed by an expert
employee of the installation company. A certificate confirming proper
installation and proper adjustment / function of all control components and
safety components must be given to the owner / operator of the system (see
sample, chapter 10).
When first putting your appliance into service, only start a moderate fire.
This enables you to avoid cracks in the firebox covering (which may still
contain residual humidity before the first firing). Slowly increase the heating
power to about 30% above nominal heat output by setting the fire 3 to 5
times to give the corrosion coating applied to the surfaces time to ‘burn
in’ properly. During this process, the paint can become slightly soft, do not
place any objects on the stove and do not touch the appliance. During this
burning-in process, an unpleasant yet harmless odour (sometimes accom-
panied by the build-up of smoke) may be given off. It is therefore important
to ensure that the room is well ventilated during the burning-in process.
Open all doors and windows to the outside of the building.