Spatherm SEO L, Инструкция по установке и эксплуатации

Страница: 11 / 40

GB
GB
11
2.4.2 SEPARATE COMBUSTION AIR SUPPLY
The stove can be supplied with combustion air separately. The separate
combustion air connection is located on the underside of the appliance
(Ø = 100 mm). The combustion air line to be attached can be connected
underneath or at the back. A connection is integrated in the plinth for a
bottom connection.
To connect up combustion air, the following steps must be taken.
Assembly of the combustion air channel on the underside of the
appliance:
1. Place the appliance above the combustion air port in the floor and
remove the cladding plate (Fig. 3a).
2. Next, remove the sealing cover (Fig. 3b).
3. Connect the combustion air neck to a flexible and removable combustion
air line. If the combustion air connection is rigid at floor level, the sepa-
rate combustion air nozzle supplied must be pushed into the connection
to form an airtight seal.
4. Finally, press together the combustion air line and install the combustion
air neck (Fig. 3c).
Fitting the combustion air channel to the back of the appliance:
1. First of all, unscrew the outer and inner cover plates (Fig. 3d).
2. Now fit the combustion air nozzle (Figs. 3e+f).
3. Lastly, connect the combustion air nozzle with the combustion air line.
When connecting a pipe connection to the combustion air neck, the com-
bustion air can be supplied to the stove from the outside or from other
rooms such as the cellar. When connecting the stove to a combustion
air line, the TROL instructions (technical rules), DIN 18896, etc. must be
observed and applied.
1 Cladding plate
2 Cap
3 Combustion air neck
In particular, ensure that the dimensions of the pipes are adequate!
2
3
Fig. 3a Fig. 3b
Fig. 3c Fig. 3d
Fig. 3e
1
Fig. 3f
2
3
3