SR85 REMOTE CONTROL CAR ALARM SYSTEM
12
BOOT AND BONNET SWITCHES
If your vehicle is not fitted with Boot/Bonnet switches which operate
the interior light these switches are available from Sparkrite as an
accessory kit. The Switch Kit (Part No. SR910) should be installed
and connected as shown in Fig. 6. Ensure the fixing screw for the
switch makes a good earth contact, crimp a piece of wire to the
switch terminal and then connect into the existing interior light
circuit.
Fig. 6
SHOCK SENSOR
The SR85 includes an electronic shock sensing device to detect
sudden impact or shock transmitted through the body work of the
vehicle.
The sensitivity adjuster is located on the rear of
the main alarm unit.
To set the shock sensor adjustment:
1)
Remove the adjuster blanking plug, arm the alarm and wait
for the 30 second arming period to elapse.
2)
Starting with the adjuster at minimum, progressively increase
the sensitivity using a SMALL flat bladed screw driver, until
the shock sensor detects a sharp blow to the centre of the
windscreen with the flat of the hand triggering the alarm.
3)
Refit the adjuster blanking plug to prevent water ingress.
NOTE:
Do not set the shock sensor at a higher than
necessary setting otherwise false alarms will result. If
a bonnet switch is fitted please ensure that the switch
is held closed (or disconnected) to eliminate the circuit
whilst adjusting this feature.
