Sparc E35202-05, Руководство по установке

Страница: 40 / 62

Power On the Host Through the Front Panel (CLI)
40 SPARC T5-1B Server Module Installation Guide • May 2014
■
9600 baud (the default, but can be set to any standard rate up to 57600)
■
Disable hardware flow control (CTS/RTS)
2. Connect the dongle cable to the UCP connector on the front panel of the server
module.
If possible, use a three-connector UCP-3 dongle cable rather than a four-connector UCP-4. See
“Dongle Cables” on page 24 for details.
3. Connect a terminal or terminal emulator to the dongle cable.
■
For a UCP-3 dongle cable, use the RJ-45 connector.
■
For a UCP-4 dongle cable, use the DB-9 serial connector (TTYA). If you need to make an
RJ-45 connection to a UCP-4, do so through a DB-9-to-RJ-45 adapter attached to the DB-9
connector.
The Oracle ILOM login prompt is displayed on the terminal or terminal emulator.
4. Type the user name and password when prompted.
The default user is
root
. The default password is
changeme
.
You are now logged into Oracle ILOM on the server module SP.
5.
If you do not plan to use the preinstalled OS, do not perform the remaining
steps.
Instead, go to “Reach a State to Install a Fresh OS (Oracle ILOM CLI)” on page 49 .
6. Power on the host.
->
start /System
Are you sure you want to start /System (y/n)?
y
Starting /System. . .
The server module initializes.
7. Switch communication to the server module host.
When the Oracle ILOM prompt appears, type.
->
start /HOST/console
Are you sure you want to start /HOST/console (y/n)?
y
Serial console started. To stop, type #.
The server module might take several minutes to complete POST. If a boot device installed with
Oracle Solaris OS is accessible locally, the server module boots. Otherwise, the server module
uses the
boot net
command to seek a boot device on the network.
You are now connected to the server module host.