Side draw handles dispense product from their respective hoppers. The
middle draw handle twists product from the left and right hoppers.
1.
OPEN draw valve (Handle Down) until desired amount is dispensed
2.
CLOSE draw valve (Handle UP) when finished dispensing
Adjustment screws below draw handles control dispensing speed.
•
Tighter (clockwise) reduces speed
•
Looser (counter
-
clockwise) increases speed
CLOSED
OPEN
NOTE:
If machine doesn’t turn on, turn power OFF, repeat steps 1 to 5. If problem persists, contact
service team.
CAUTION:
If machine makes any abnormal noise during reset, immediately switch power OFF and
contact service team.
IMPORTANT: Machine shuts down automatically if cylinders experience freeze
-
up
(usually because
the viscosity is set too high for the selected product) to prevent motor damage. Use the
Quick Freeze
function to return the machine to normal operation.
1.
Switch power switches OFF
.
2.
Press power reset button underneath front overhead,
(
If you can not find power reset
button, please disassemble the machine panel and press Reset button on Inverter
).
3.
Press and hold STANDBY button for 3 seconds and turn on Defrost mode.
4.
Press RESET on Control Panel and re
-
prime. Lift up prime plug and make sure product
comes out from bottom prime port. Close prime plug.
5.
Press RESET then WASH button. Once product comes out of two small holes on pump
cover, press RESET to complete priming.
6.
Observe machine performance and return to normal use if functioning properly.
Quick Freeze
Dispense product
14
Machine power reset
Turn on freezing immediately to cool product down to serving consistency.
Use when quick serve is required after long idle period.
To turn on Quick Freeze:
•
Under FREEZE mode press ICE CREAM button
Operating Control :
Freeze
NOTE:
If adjustment screw is tightened too far, product may not
dispense. If this occurs, loosen adjustment screw until product dispenses.
Lower
Higher
Overrun is the amount of air mixed in with the product.
The higher the overrun, the higher the amount of air in each serving.
1.
Turn
suction
tube
lever
to
the
LEFT
to
reduce
overrun;
Turn
suction
tube
lever
to
the
RIGHT
to
increase
overrun.
2.
Six
overrun
levels
total.
Recommend
to
use
2
-
5.
3.
Overrun
and
texture
change
will
be
visible
after
6
-
8
dispenses.
1
2
3
4
5
6
Overrun
Levels
Adjust Overrun (For Pump Feed Models)
CAUTION: Overrun setting can differ between products. Setting too high of overrun can cause the
machine to malfunction. When increasing overrun, you may need to reduce the viscosity setting.
