Space SDI110K, Руководство пользователя

Страница: 47 / 76

47
0492-M001-0-P1 SDI110K-KC – SDI120-C
SDI125-C – SDI125M-MC
8 TROUBLE SHOOTING
Here is a list of some of the possible problems encountered during operation of the Lift. SPACE may not be held liable for any damage
to persons, animals or objects in the case of action by unauthorised personnel. For this reason, should a fault occur, you should contact
the technical services as soon as possible for instructions to carry out actions and/or adjustments in maximum safety, to prevent danger
to persons, animals or objects.
Technical services must be called. Take no action yourself.
Turn the main switch to “0” and padlock it in case of emergency and/or maintenance on the lift.
PROBLEM CAUSE ACTION
Lift does not work
• main protection fuses broken • replace
• Fusibili e trsformatore interrotto • replace
• wiring system faulty • check
Lift does not complete rise run
• motor heat probe disabled • wait for reset
• load exceeding nominal capacity • respect regulations (section 1)
• mains voltage too low • check
Irregular lifting run
• air in hydraulic system • operate some complete runs without load
• insuffi cient oil in tank • top up oil (with lift at ground level)
Lift descends automatically then stops within
100 mm
• blocking valve dirty • clean
• leak in one cylinder • replace gaskets
Descent is extremely slow
• capacity regulation valve does not work
properly
• see “maintenance” section
Warning: with empty, unloaded, lift down motion is slow.
Motor runs as normal but rise speed is ex-
tremely slow
• descent valve partially open • see “maintenance” section
• pump suction fi lter partially blocked • clean fi lter
• worn or damaged pump • replace pump
• calibration valve faulty • contact technical services
Release cylinder failed to work.
• no air in system • check
• release solenoid valve faulty • see “maintenance” section
• release cylinder gasket worn or damaged • replace gasket
• compressed air tubes crushed or
damaged
• check tubing
8