Space-Ray CBU09, Инструкция по установке, обслуживанию и эксплуатации

Страница: 31 / 55

Form 483S
Rev Jan 09
Page 29 of 53
6.3.6 Position the Reflector End Panel (notched) over the Radiant Tubes and into the end of the Reflector Panel with
the End Panel flange flush with the end of the Reflector. Secure the Reflector End Panel to the Reflector Panel
by use of 6 - U type speed clips provided (fastenings pack); 2 clips per facet of Reflector Panel, as shown in
Fig. 19.
Repeat the procedure to attach the Reflector End Panel (plain) to the opposite end of the Reflector.
6.3.7
The appliance should now be raised and suspended from previously fixed chains or drop rods as detailed in
section 5.1, at suspension points indicated in Fig. 19. Rope or webbing slings should be used when lifting from
above. If using a forklift to position the appliance, ensure that the appliance is balanced on the forks prior to
lifting.
6.3.8
If combustion air is to be ducted to the appliance, attach a length of flexible ducting to the Air Inlet
Adaptor of the Control Box by use of a suitable hoseclip. Attach the inlet end of the hose to any fixed
ducting, also by use of a suitable hoseclip, allowing for adequate movement of the appliance.
6.3.9
Connect the gas supply in accordance with Section 5.2 - Gas supply, of these installation instructions.
6.3.10 Using twin core and earth flexible supply cable as specified in Section 5.3.2, suitable for 230V~50Hz 125W
supply, connect the 3 pin electrical socket provided (fastening pack) as follows:-
Brown (Red) - to terminal marked L
Blue (Black) - to terminal marked N
Green/Yellow - to terminal marked
7
External fuse rating required - 3A
See Section 5.3 for electricity supply requirements.
NOTE: It is important for the correct function of the appliance for the polarity of the electrical supply to
be correct.