9
GB
TO START ENGINE
The choke has 3 positions: RUN (A), HALF (B) and
CHOKE (C) (Fig. 9A).
1.
Slide red STOP switch up for starting (Fig. 9B).
2.
Move the yellow choke lever (E) to
(CHOKE)
(Fig. 9C).
3.
Push the primer bulb (F) 10 times (Fig. 9D).
4.
Push the operating lock forward: Press on the
operating lock (I) with your right hand and pull the
throttle lever (H) with your index finger. Now push
the lever catch (G) forward, keep it pressed and
release the throttle lever (H). The throttle lever
(H) then locks into place in the “half throttle”
position (Fig. 9I).
5.
Place saw on a firm, flat surface. Hold saw firmly
as shown. Pull starter rapidly 4 times. Beware of
moving chain! (Fig.9F)
6.
Move yellow choke lever (D) to
(HALF)
(Fig.9G).
7.
Hold saw firmly and pull starter rapidly 4 times.
Engine should start (Fig. 9H).
8.
Warm up for 10 seconds. Depress and release
trigger (H) for IDLE, then go to step 9 (Fig. 9I).
9.
Move yellow choke lever (F) to
(RUN) (Fig.
9J). If engine failed to start, repeat these
instructions.
RE-STARTING A WARM ENGINE
1. Make sure the switch is in the ON position.
2. Move the choke lever to
(HALF).
3. Depress the primer bulb 10 times.
4. Set the throttle latch.
5. Pull the starter rope rapidly 4 times. The engine
should start.
6. Move the choke lever to
(RUN).
7. Release the throttle
latch.
TO STOP ENGINE
1. Release trigger and allow engine to return to idle
speed.
2. Move STOP switch down to stop engine.
NOTE:
For emergency stopping, simply activate
chain brake and move STOP switch down.
CHAIN BRAKE OPERATIONAL TEST
Test the chain brake periodically to ensure proper
function.
Perform a chain brake test prior to initial cutting,
following extensive cutting, and definitely following
any Chain brake service.
TEST CHAIN BRAKE AS FOLLOWS (Fig. 10) :
1. Place saw on a clear, firm, flat surface.
2. Start engine.
3. Grasp the rear handle (A) with your right hand.
4. With your left hand, hold the front handle (B) [not
chain brake lever (C)] firmly.
5.
Squeeze the throttle trigger to 1/3 throttle, then
immediately activate the chain brake lever (C).
WARNING
: Activate the chain brake slowly and
deliberately. Keep the chain from touching anything;
don t let the saw tip forward.
6.
Chain should stop abruptly. When it does,
immediately release the throttle trigger.
WARNING
: If chain does not stop, turn engine off
and take your unit to the nearest Authorized Service
Center for service.
7.
If chain brake functions properly, turn the engine
off and return the chain brake to the
DISENGAGED position.
Fig. 9H
Fig. 9J
Fig. 9I
Fig. 9B
Fig. 9E
Fig. 9F
Fig. 9G
Fig. 9D
Fig. 9C
Fig. 9A
Fig. 8
H
F
E
E
G
H
I
F
A
B
A
B
C
C
Fig. 10
A
B
C
Anleitung SCS 38_SPK7:_ 20.11.2006 15:43 Uhr Seite 9
