Southworth Products
DDL Dock Lift Manual
DDL Dock Lift Manual
15
To avoid death or serious injury:
•
Only trained and/or qualified personnel shall operate this machine.
• Personnel are not permitted on the platform during operation unless handrails and
snap chains/cables are installed.
• Loads that may shift during operating must be secured before operating.
• Keep hands, feet, and loose clothing away from moving parts.
• Do not enter beneath the platform until the load has been removed and the machine
has been secured against lowering with the maintenance device(s).
• Do not load or unload the machine while moving.
• The load’s center of mass must be centered on the platform. Uneven or off center
loading may cause excessive wear or permanent damage.
• During operation, operator must be in view of the machine at all times.
When not in use the platform is to be in the fully lowered position.
To raise the machine,
press and hold the UP button on the controls. Release the button when
the platform is at the desired height.
To lower the machine,
press and hold the DOWN button on the controls. Release the button
when the platform is at the desired height.
5.1 Loading
All loads should be centered on the platform. Uneven loading can lead to excessive wear or
damage. Always secure loads that may roll or shift during travel.
6. Maintenance & Repair
To avoid death or serious injury:
•
Only trained and/ or qualified personnel shall perform maintenance or repair of this
machine.
• Pinch points exist, keep hands, feet, and loose clothing away from moving parts.
• Always use appropriate Personal Protective Equipment when performing and
maintenance or repair.
• Disconnect and lock out electrical supply before performing any maintenance or
repair
• Do not adjust the hydraulic pressure relief valve. This valve is pre-set and
adjustment may cause the machine to fail.
• Before performing maintenance or repair to the hydraulic components, relieve
pressure in the hydraulic system. See Relieving Hydraulic Pressure section.
•
Pressurized fluids can penetrate skin and cause severe injury. Do not use hands or
other body parts to detect hydraulic leaks.
• Do not enter beneath the platform until the load has been removed and the machine
is secured against lowering with the maintenance device(s). See Maintenance
Devices section.
