MASTER UNIT AS STAND ALONE FOOT SWITCH
1. Plug a 20 amp 120 Volt extension cord into the extension cord input
(13). If using a 15 amp motor or less you may plug in a 15 amp 120
Volt extension cord using a 20 amp to 15 amp adaptor plug.
2. Plug Puller’s electrical extension cord into Triggers
®
switches input (17).
3. Turn on the Master Unit by pressing the Power button (1). Power light
will indicate power to the unit.
4. Press the Stand Alone button ON (2). Light (3) will indicate unit is in
Stand Alone and may be used without the Remote or Hand Held Units.
5. If the Remote unit or Hand Units are turned on and linked there is an
indicator that will show the Master unit is in standalone mode.
• The Hand Held unit can be used to stop the pull even if the
Master unit is in Stand Alone mode.
6. Turn on puller’s power switch allowing total control to the Triggers
Master foot pedal.
7. Pushing down on the Triggers Master foot pedal (11) will start the puller’s
motor. Lifting off of the Foot Pedal will stop the puller’s motor.
REMOTE UNIT AS STAND ALONE FOOT SWITCH
1. Plug a 15 amp 120 Volt extension cord into the extension cord input (17).
2. Plug equipment electrical extension cord into Triggers input (17).
3. Turn on the Remote Unit by pressing the Power button (1). Power light
will indicate power to the unit.
4. Switch the Stand Alone button ON (2). Light (3) will indicate unit is in
Stand Alone and may be used without the Master or Hand Held Units.
5. If the Master unit or Hand Units are turned on and linked there is an
indicator that will show the Remote unit is in standalone mode.
• The Hand Held unit can be used to stop the pull even if the Remote
unit is in Stand Alone mode.
6. Turn on pusher’s power switch allowing total control to the Triggers
foot pedal.
7. Pushing down on the Triggers Foot Pedal (11) will start the feeder’s
motor. Lifting off the Foot Pedal will stop the feeder’s motor.
Operation cont.
