Before using the Triggers
®
system all battery powered units should be
fully charged
1. Turn on Master Unit by pressing the power button (1). Power light
(4) will indicate power to the unit.
2. Turn on the Remote Unit by pressing the Power button (1). Power
light will indicate power to the unit.
3. Turn on the Hand Held Units by pressing the Power button (1).
Power light will indicate power to the unit.
4. The Master unit will scan for Remote or Hand Held units. As they
are found, an LED on the amperage indicator will light up and the
Signal Strength Indicator on the corresponding Remote or Hand
Held Unit will display signal strength. This process can take several
seconds.
5. Once all units are accounted for, Press the pedal on the master unit
and all units’ “LINKED” light will come on.
BEFORE USING THE SYSTEM TO PULL CABLE VERIFY THAT ALL UNITS
FUNCTION AS OUTLINED BELOW
• Prior to engaging the foot pedals, the indicator light will show
“STOP”.
• If both pedals are engaged the “RUNNING” indicator will be on and
the output to the feeder or puller’s motor will be turned on.
• If either pedal is lifted the puller will stop and the indicator light will
read “READY”.
• If stop button is pressed on any Hand Held unit, the puller will stop
and the “STOP” light will flash on the Master, Remote and Hand unit
on which it was pressed. This is a “forced stop”. The other Hand
Held units will have a solid “STOP” light. To clear this condition hold
down the stop button on the unit on which it was pressed until the
“STOP” light quits flashing.
Operation
