Questions? Call Toll Free at 1-800-737-2112
Copyright © 2018 MAT Engine Technologies, LLC
EN - 12
EN - 13
Contact Information:
Problem and Solutions:
PROBLEM
POSSIBLE CAUSE(S)
SOLUTION(S)
Fails to split logs.
1. Log is improperly positioned.
2. The sizes or hardness of the
log exceeds the capacity of the
machine.
3. Wedge cutting edge is blunt.
4. Oil leaks.
5. Unauthorized adjustment
was made to the maximum
pressure limiting screw. Lower
pressure rating was set.
1. Refer to “Log Splitter Operation”
section (page 9) for perfect log loading.
2. Reduce the log sizes before splitting.
3. Refer to “Sharpening Wedge“ section
(page 10) to sharpen the cutting edge.
4. Locate leak(s) and contact the dealer.
5. Contact the dealer.
The ram moves unsteady,
makes an unfamiliar noise or
vibrates excessively.
1. Lack of hydraulic oil and/or
excessive air in the hydraulic
system.
1. Check oil level for possible oil refilling.
2. Contact the dealer.
Oil leaks around cylinder ram
or from other points.
1. Air sealed in hydraulic system
while operating.
2. Vent screw is not tightened
before moving the Log Splitter.
3. Oil drain bolt with dipstick is
not tight.
4. Hydraulic control valve
assembly and/or seal(s) worn.
1. Loosen vent screw by 3 to 4 rotations
before operating the Log Splitter
2. Tighten the vent screw up before
moving the Log Splitter.
3. Tighten the oil drain bolt with dipstick.
4. Contact the dealer.
Electric motor will
not run.
1. Motor has encountered
overload and activated the
reset button.
1. Push the reset button when motor has
cooled.
Troubleshooting
• Save all instructions
You may have further questions about assembling, operating, or maintaining this Log Splitter. If so, you can
contact our Technical Service Department at 1-800-737-2112 (English only).
You may also write to:
METL Corporate Office - CORRESPONDENCE ONLY
ATTN: Technical Service – METL
6700 Wildlife Way
Long Grove, IL 60047
Technical Service
• Save all instructions
If you need assistance or have any questions,
CALL TOLL FREE: 1-800-737-2112.
When contacting the Technical Service Department, have ready:
• Your Name
• Your Address
• Your Phone Number
• Model Number of Product
• Date of Purchase (include copy of receipt for written requests)
