10 of 22
Copyright 2015 by Southern Pride Distributing, LLC Volume 2
INSTALLATION INSTRUCTIONS FOR RESTRAINING DEVICE
1. Restraining device should be installed parallel (in line) with the power supply cord.
2. Restraining device parts list: See Figure A for a photo of the materials contained in the restraining kit.
3. Attach staple bracket: Fasten the staple bracket (Figure B) to a stud located in the wall that the power
receptacle is located on. Use the (4) #10 x 1” screws and plastic anchors if needed.
4. Install eyebolt: Thread jam nut onto eyebolt. Screw eyebolt into threaded hole above the power cord
connection point on back of smoker. Tighten eyebolt and then tighten jam nut to keep eyebolt tight
(Figure C).
5. Connect restraining cable: Attach one end of cable using the spring loaded hook to the eyebolt. Attach
other end of cable to the staple bracket using the other spring loaded hook.
6. Note: To provide strain relief the restraining cable must be shorter than the power supply cord. The
restraining device should always be connected when the smoker is in use.
Figure A
1. Staple bracket
2. Eyebolt with jam nut
3. Restraining cable
4. Spring loaded hook
5. #10 x 1” screws
6. Plastic anchors
7. Instruction sheet
Figure B
Figure C
1
2
3
4
5
6
7
