Southbend KECT-05F, Руководство пользователя

Страница: 9 / 27

MAINTENANCE
SECTION 5: SELF-GENERATING COUNTER TOP
STEAM JACKETED KETTLES
GENERAL MAINTENANCE
No general maintenance is required other than adhering to the Cleaning Procedure
instructions on page 7.
LOW WATER LEVEL
Proper water level must be maintained within the jacket for the kettle to operate.
Depletion of water may occur from excessive opening of, or leakage through the safety
relief valve.
If water is below required operating level, either initially at startup or during
use, the kettle will automatically shut off, refuse to operate and the LOW WATER
signal light will come on.
In order for the kettle to operate, the following procedure must be followed -
a) Trip the safety relief valve lever to relieve all pressure from kettle jacket.
b) At exterior rear of kettle jacket remove nut from Air Vent.
c) Insert funnel into Air Vent opening and slowly add the indicated amount of clean
water for
EC-5 and EC-6 Models add 52 ozs.
EC-10 Model add 108 ozs.
EC-20 Model add 144 ozs.
d) Replace Air Vent nut.
e) Follow Air Venting Instructions below.
f) Continue normal Operating Procedure of kettle.
AIR VENTING INSTRUCTIONS
Periodically check Pressure Gauge when the kettle is cold. Reading should be in
VACUUM zone between 20 to 25, otherwise air is present and efficient heating will
not occur.
To remove air, set Thermostat Knob at 8 and heat empty kettle until TEMPERATURE pilot
tight goes off.
Open Air Vent nut one full turn for 10 seconds to exhaust air from kettle jacket.
Close Air Vent nut.