O&M Manual v2
Page 25
8.
BlastOff™ - Leak Detection System (Optional)
The BlastOff™ – Leak Detection System is a patented system
when installed into a N
2
-BLAST
®
will detect line leaks
downstream or within the N
2
-BLAST
®
. Line leaks could be
due to a cut hose, a leaking fitting, etc. These leaks are
potential safety hazards; they can cause the N2 to deplete
quickly, and could cause your N
2
-BLAST
®
system to run in
excess (decreasing the life of the unit).
Once a leak has been detected, the BlastOff™ can be set to either initiate a buzzer, activate a red warning light
(inserted into the N
2
-BLAST
®
cabinet), and/or shut off the N
2
-BLAST
®
until the problem has been remedied.
To reset the BlastOff™, simply turn off the N2- GEN™ power switch and turn it back on. The N
2
-BLAST
®
can be ordered with the BlastOff™ System Factory installed or the system can be retrofitted in the field.
Some rewiring and drilling required to field install.
Factory settings will give both an audible and visual alarm as well can shut the compressor down when
ordered to. The buzzer and light will continue until the system has been reset. Never reset over and over, if
the BlastOff™ goes off, there is a real potential issue. Consult your installer or the factory for a solution.
The label below and the Logo above will be on your N
2
-BLAST
®
if factory installed.
