South-Tek Systems N2Blast FPS-1250, Руководство пользователя

Страница: 10 / 29

FPS-650 and FPS-1250 South-Tek Systems
Version: 7
Revision Date: 9/6/19 Page 10 of 29
Lock and Unlock Controller
To utilize the buttons on the front of the controller the unit must be unlocked.
If the system is
displaying “ LOCK ” the Mode Select Button may be pressed
and held to unlock the controller (Repeat this step if a system lockout is
desired). Unlocking the controller allows access to two features:

Alarm Simulation (5) – Hold the Alarm Simulation Button for 3
seconds to activate. This will simulate an alarm condition and trip
the alarm dry contact in the unit (if installed) for 2 seconds so that
proper functioning can be confirmed.

Filter Change Reset (0) – When a new FRP (Filter Replacement Kit)
is installed, the 1000-hour filter change time must be reset. After
replacing the filter elements, press and hold the Filter Change Reset
Button for 7 seconds. An audible beep will confirm that the filter
change time and filter alarm are reset.
4 PRODUCT INSTALLATION
UNPACKING AND PREPARATION
The N
2
-BLAST® FPS-650 System’s cardboard carton should be carefully
opened and all parts should be inspected for damage upon receipt. For
the
N
2
-BLAST® FPS-1250 system, a wooden crate is used for shipping and
should be opened on the side noted on that crate. Identify and verify that
all parts listed on the packing list are present and undamaged. South-Tek
Systems (STS) is not responsible for damages that have occurred during
the shipping and handling of the
N
2
-BLAST® . Any visual damages should
be immediately documented and reported to the shipping company
responsible. Then, contact STS at (888)526-6284 to assess the damages
only after the shipping company has been notified.
Until Installation:
o
Store the N2-BLAST® in a dry and climate controlled (60-80°F
recommended) room.
o
Always keep N2-BLAST® in an upright position / or in box as
shipped.
o
Do not connect the AC power cable until this manual has been
read completely and all connections are made as stated within.
o
Keep all gas lines dry so moisture does not enter generator upon
hookup.
o
Never place/stack objects on top of the N2 - BLAST® .
To remove FPS-1250 from crate, unbolt cabinet from the crate. Carefully, lift
unit from the crate and set it on the floor. Use a floor jack to move it to the
final location. Once in place, unbolt the 4 colored bolts at the bottom of the
cabinet.