South Bend Tools SB1102, Руководство пользователя

Страница: 19 / 60

South Bend Tools
For Machines Mfd. Since 12/21 Model SB1102
-17-
P R E P A R A T I O N
6. Press Sanding Drum Motor ON button (D)
to start drum motor (see Figure 12 on Page
16). ON button will illuminate and sanding
drums will start. Sanding drums should
run smoothly with little to no vibration or
rubbing noises.
Emergency Stop Button
T
o
R
e
s
et
Tw
i s
t
C
lo
c
kwis
e
Figure 13. Emergency Stop button.
5.
Twist Emergency Stop (B) button clockwise
until it pops out to reset switch (see Figure
13).
— Both motor OFF buttons (E and G) will
illuminate after Emergency Stop button is
reset.
— If sanding drums are operating smoothly,
proceed to Step 7.
— If sanding drums are not operating
smoothly, turn machine OFF and correct
the problem before continuing. Refer to
Troubleshooting on Page 41 or call
Tech Support for help.
Inspections &
Adjustments
The following list of adjustments were performed
at the factory before your machine was shipped:
• Drum Alignment ..............................Page 30
• Pressure Roller Height ...................Page 34
• Conveyor Belt Tracking .................Page 35
• V-Belt Tension ..................................Page 37
Be aware that machine components can shift
during the shipping process. Pay careful
attention to these adjustments as you test run
your machine. If you find that the adjustments
are not set according to the procedures in this
manual or your personal preferences, re-adjust
them.
7.
Press Conveyor Motor ON button ( F) to start
conveyor motor (see Figure 12 on Page
16). ON button will illuminate. Turn the
Conveyor Speed Control dial (C) clockwise
to increase speed. Conveyor should move
smoothly with little to no vibration or
rubbing noises.
— If conveyor belt is running smoothly,
proceed to Step 8.
— If conveyor is not operating smoothly,
turn machine OFF and correct the
problem before continuing. Refer to
Troubleshooting on Page 41 or call
Tech Support for help.
— If both motors do not start, the
Emergency Stop safety feature is working
correctly. Congratulations, the Test Run
is complete!
— If either motor does start (with
Emergency Stop button depressed),
immediately disconnect machine from
power and DO NOT USE. The Emergency
Stop safety feature must work properly
before proceeding with regular operations.
Call Tech Support for help.
8. Push Emergency Stop button (B) to turn
machine OFF.
9. WITHOUT resetting Emergency Stop
button, press Sanding Drum ON button (
D)
and Conveyor Motor ON button (F). Motors
should not start.
Note: New V-belts often stretch and loosen up
during the first 16 hours of use. After this period,
they should be inspected and re-tensioned if
necessary.