ST2883 Series Operation Manual Chapter 5 Introduction to [SETUP]
5-1
Chapter 5 Introduction to [SETUP]
Press SETUP to enter the <Setup> page. This is a toggle key, by pressing it, the displayed page can be toggled
among <Setup>, <Int. File>, <Ext. File>.
5.1 Introduction to icons of soft keys
Numerical arrow key. Lighten this icon to enable this key. Respectively press the four keys, 8, 2, 4,
6, the cursor will move up, down, left and right. When the icon becomes dark, the numerical arrow
key is disabled. Likewise the cursor can be moved by pressing START (except in the measure display
page).
NOTE: When the icon is lightened, the original numerical input function for the four numerical keys
will be invalid.
Coarse adjustment key used to increase the selected value.
Coarse adjustment key used to decrease the selected value.
Fine adjustment key used to increase the selected value.
Fine adjustment key used to decrease the selected value.
5.2 Measurement setup page
Figure 5-1 Measure setup page
Follow parameters can be set in <Setup>.
Impulse voltage
(Imp Volt)
Sampling rate
(Samp)
Test impulse
(Test Imp)
Erase impulse
(Erase Imp)
Voltage adjustment
(Volt ADJ)
Wave display
(Wave Disp)
Trigger mode
(Trig Mode)
Delay time
(Delay Time)
Breakdown voltage
test
(BDV)
